Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Proper torque for Crank Pulley bolt? I've found some possible contradictions.... 200 1993

posted by  Ken C on  Wed Jun 21 05:36 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 11:39 CST 2014
[RELATED]

Hi. I'm putting the crankshaft pulley back on, following a timing belt, shaft seals and tensioner replacement.

The IPD do-it-yourself DVD says 122 ft-lbs.
Bentley manual, page 215-5, says: stage 1, 44 ft-lbs, and then stage 2, "additional 1/6 turn (90 degrees)".

That last one has me confused -- a 1/4 turn is 90 deg., but a 1/6 turn is 60 deg. I imagine the torque for a 1/4 vs. a 1/6 turn is substantially different!
[by the way, I used the "tool", not the rope trick, to hold the pulley, in case it makes a difference in the torquing technique.]

What's the right tightening procedure?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Proper torque for Crank Pulley bolt? I've found some possible contradictions.... [200][1993]
posted by  Ken C subscriber  on Wed Jun 21 05:36 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.