Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Proper torque for Crank Pulley bolt? I've found some possible contradictions.... 200 1993

uid 18083's pic
posted by  lucid on  Wed Jun 21 07:30 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 12:31 CST 2014
[RELATED]

The 122 ft-lbs is for B21/23. IPD should have been explicit on that, IMO. And should also have included the B230 spec.

Bentley is wrong on the 90°. Should be 60° for B230 (per Volvo greenbook), and it takes a strong pull. I have to extend my breaker bar with a pipe to get that 60° in one motion.

I also use a 60° cardboard template and position it to determine the "ending position" for the breaker bar.
--
Bruce Young
'93 940-NA (current), 240s (one V8), 140s, 122s, since '63.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Proper torque for Crank Pulley bolt? I've found some possible contradictions.... [200][1993]
posted by  Ken C subscriber  on Wed Jun 21 05:36 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.