Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

1982 242 LH-jetronic Idle Control Valve Troubleshooting 200 1982

posted by  jimjmorris on  Fri Jul 14 05:56 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Sep 29 19:45 CST 2014
[RELATED]

1982 Volvo 242 GLT, B21 with Chrysler Ignition, EFI LH Jetronic FI

While driving to the bank today at lunch, I was making a turn and clutch in, off the gas, the car died. It will restart only with the gas pedal pushed in. So, for now I just adjusted the throttle cable to keep it open enough to run at about 1500 rpm.

I think it is reasonable to assume this is the idle control valve, correct? The car drives the same with it plugged in or not.

I consulted the FAQ but am not sure if it applied to my early 240 EFI unit.

1) How do I test that the idle control valve plug (three terminal) is supplying juice? which lead is it?
2) What model LH jetronic did they use in '82? 2.2? 2.4?

Thanks in advance! Jim





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1982 242 LH-jetronic Idle Control Valve Troubleshooting [200][1982]
posted by  jimjmorris subscriber  on Fri Jul 14 05:56 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.