Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2005 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

FUEL PRESSURE REGULATOR DIAGNOSIS FOR 93 940 900 1993

I searched the Brickboard including the FAQ's and couldn't find the specification for the fuel pressure measured at the injector rail. Couldn't find it in the Haynes manual either. Does anyone know what the correct pressure should be? I have recently hooked up a pressure gauge to the schrader fitting on the rail and have it mounted in front of the windshield. When I first had it connected, it read about 30 psi for perhaps two hours of running. It is now around 40 psi and has been there for a couple of days. I have tested the fuel pump (closed off return line and pressure jumped), checked vacuum line at regulator (increase pressure when removed) and checked the return line for blockage.
Before I plunk down $62 for a new regulator, I would like to know what the pressure should be.
As background, I have been trying to eliminate an intermittent no-start porblem and I think I have it narrowed down to the fuel system.
Any help is appreciated.
Al Stensby.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New FUEL PRESSURE REGULATOR DIAGNOSIS FOR 93 940 [900][1993]
posted by  Papa Al subscriber  on Fri Jul 14 13:02 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.