Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2014 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear pad replacement issues 200 1991

posted by  chaddcurtis on  Fri Jul 21 06:18 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jun 2 04:57 CST 2009
[RELATED]

I replacing pads and rotors all around on my '91 240 SE wagon. I have started with the rears, installed the new rotors, and cleaned everything up. Before removing the old pads, I pushed the caliper positions back to make room for the new pads. When I go to install the new pads, I can install the pads on the outside of the rotor but there is not enough space to get the pads installed on the inside, even without the shims. I moved to the other wheel thinking I might have a piston that is hanging, but it has the exact same problem. Any thoughts greatly appreciated. By the way, they are ATE calipers.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rear pad replacement issues [200][1991]
posted by  chaddcurtis  on Fri Jul 21 06:18 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.