Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

M46 rear oil seal removal 200 1982

posted by  Rolandp on  Thu Aug 10 10:27 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 15 17:36 CST 2014
[RELATED]


I must replace the rear oil seal on my m46 transmission very soon. I do not seem to reach any article with the search button.

I do not have the specific puller to remove the old seal.

Can I remove it with a screw driver or other tool? I could make some tool to slide behind the old seal but it would be hard to make one that pull at two places.

Should I use some ''Permatex high tack spray a gasket'' on the new seal before sliding it in? I do not have the appropriate tool for that either but i will push it slowly and as evenly as possible with a hammer.

Am I opening a can of worm?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M46 rear oil seal removal [200][1982]
posted by  Rolandp  on Thu Aug 10 10:27 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.