Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

240 Error Codes 200 1991

Good Day All,

I did the test to get my error codes since the car is turnign over but not firing up. It will start for a few seconds if it has been sitting for awhile. Anyway my error codes and what the Volvo Code Retrieval page says is wrong.

2 - 1 - 3 Throttle Switch Signal
2 - 3 - 2 Lamda Adjustment
1 - 1 - 3 Fuel Injectors

I am assuming I need to repalce the Throttle Switch and put new Fuel Injectors in the car. Is it possible or recommended to use used ones from the auto salvage yard if they look good? Is there anything I should know before doing these 2 things. I know the Lamda adjustment is the 02 Sensor (correct) and I will replace that but that is not what is keeping my car from starting, so I been told.

I also did a coil wire test by removing the coil wire from the distributor and turning the key and I saw very little spark very random. I read on another thread that this means I should replace the crank sensor. Is this correct?

Lastly, where is the crank sensor and Throttle Switch? I have searched online and find a discribtion of what they are but no photos of where they are.

Thanks again for all the advice. It means alot to us. Cheers






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 Error Codes [200][1991]
posted by  Turbo Glennbo  on Mon Aug 21 12:14 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.