Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2004 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacement end links don't fit 900 1994

posted by  yrots on  Thu Aug 31 13:53 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Apr 12 11:19 CST 2014
[RELATED]

Upgrading to IPD swaybars purchased via auction site. I purchased replacement end links after twisting off one during the installation of the bars. The replacements from FCP Groton arrived but the lower bushing ID is too small for the bolt to pass through. It measures somthing like .43 inches ID and the bolt is somthing like .46 inches. Should the bushing be bored out for the bolt or should the bolt "cut " its way through? I tried searching the archives w/o any luck.
Thanks in advance for any help and advice.

Dirk
--
Dirk Story






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacement end links don't fit [900][1994]
posted by  yrots  on Thu Aug 31 13:53 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.