Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Driveline vibration 200 1988

Happy Labor Day

and laboring, I am. I properly indexed the driveshaft, replaced the bad u-joint (rear), the other two were fine. I replaced the tranny mount. The center bearing turns freely, quietly and without any "grit' feeling to it. I drained and refilled the differential fluid. The fluid level is as recommended.

The car shook while putting in reverse to back up on Friday and I still have vibration from 45 - 60mph. I have parts for center bearing and bushing and motor mounts. I'm wondering if I should just replace them all and see what happens.

The other side is that, rather than just throw parts at it, i'd like to solve the problem. Can a shop re-balance the driveshaft?

Thanks for your replies.

Stormie - '88 240DL, 513,000 original miles, original owner. Second tranny






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Driveline vibration [200][1988]
posted by  Stormie  on Mon Sep 4 05:42 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.