Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Removal of intake to do wiring harness? 200 1984

posted by  xander450 on  Wed Sep 6 03:21 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

It was suggested to me that I should remove the intake manifold to replace my wiring harness. Is this really necessary? It looks to me like all that's underneath the manifold is a couple of sensors - should be easy enough to unplug those and reconnect the new wires by feel, right?

Also, the harness came with a big rubber plug on it - looks like what I'd put on a harness where it went through a firewall. Does the main engine harness actually pass through the firewall somewhere? I thought there were fender subharnesses that did that.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Removal of intake to do wiring harness? [200][1984]
posted by  xander450  on Wed Sep 6 03:21 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.