Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2011 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

WON'T STAY RUNNING 700 1989

posted by  Jimmy T. on  Thu Sep 7 10:08 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I'VE HAVE A NO START PROBLEM WITH MY 740, WHICH i GOT SEVERAL REPLIES TO IN LATE AUGUST; Thanks for the help. Still the bugger won't stay running even thought it will fire. I rechecked the sensors and the wiring etc. I also did the test to check the load sicgnal from the fuel ecm to the ingnition control. The Volvo green books say the voltage from pin 25 to pin #8 on the Ignition control should be 0.1V with te key on and engine not running. I have a reading of .001V at the Ign. control end of the wire and .015V if taken with a pin in inserted into the back of the #25 connection at hte LH fuel control harness. I've seen a few misprints in the Volvo green books so I'm wondering if anyone know whether the 0.1v spec is correct, or if there is a mis print?

If 0.1 is corrct as apposed to .01v then it would indicate the ECU is okay, right?

fyi this car has about 330000 miles.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New WON'T STAY RUNNING [700][1989]
posted by  Jimmy T.  on Thu Sep 7 10:08 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.