Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2004 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Broken idle adjusting screw 120-130

posted by  Danny on  Tue Sep 12 16:00 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 6 22:01 CST 2014
[RELATED]

Need some help here. Hadn't needed to adjust carbs for too long - everything has been running just fine. Front idle adjusting screw twisted right off flush with the carb body!! So now what? How do I get the remaining screw out? Tried grabbing the less than 1/8" remaining below the flange with a needle nose vise grip and got it to move a little, but not enough space or purchase to screw it downards to remove it. I'm trying to solve this without dismantling and removing the carb from the manifold. Any ideas? Would drilling it out be stupid? How hard is this screw steel anyhow? Don't want to even come close to drilling out the threads in the carb body - I had these carbs rebushed,
I have spare replacement screw.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Broken idle adjusting screw [120-130]
posted by  Danny  on Tue Sep 12 16:00 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.