Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Help me figure out if there is a problem in the wiring going to the pre-pump? 200 1990

posted by  someone claiming to be VolVolina on  Sun Sep 17 08:20 CST 2006 [RELATED]

I wanted to check the wiring before I put the sender unit back in. I checked continuity between the black wire at the plug in the trunk and the positive terminal at the pre-pump. There is no continuity. Shouldn't there be? The solder joint inside the sender unit looks good. Could I remove the plastic part on top of the sender unit and check for an open there or must that remain sealed?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help me figure out if there is a problem in the wiring going to the pre-pump? [200][1990]
posted by  someone claiming to be VolVolina  on Sun Sep 17 08:20 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.