Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to access wiring inside pillar between front and rear doors? 200 1993

posted by  jthorner on  Wed Oct 18 15:38 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jan 4 04:02 CST 2010
[RELATED]

I've been tracking down the cause of inoperative door switched interior lights on our '93 245. Several of the door switches were not working correctly, so I purchased four replacements and am installing them. In doing so I discovered that the wiring for the right rear switch had broken off inside the pillar at the point where it was crimped to the spade connector. Looking into the little hole with a flashlight and poking around I cannot see the rest of the wire.

How do I get in there? Do I need to somehow remove the plastic panel which covers the inside of the post, and if I do figure out how to remove that panel will I see anything other than more metal?

TIA for any help!

John





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to access wiring inside pillar between front and rear doors? [200][1993]
posted by  jthorner  on Wed Oct 18 15:38 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.