Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Pictorial dismantling of 7/9-series front seats. 700

posted by  Kane on  Fri Oct 27 10:42 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

(If Steve want to add this to the entries already in the FAQ ...)


Quick little graphical view on how to dismantle the front seats for a 7/9 series to replace the cover, foam, and/or lumber support. Both driver and passenger seats are very similar.















Use common sense to remove any additional parts. It's wise to use a piece of sturdy fabric about a square foot (ie. commercial low-pile carpet) under the bottom seat cushion when reassembling to avoid the wires from cutting into the foam in the future. For simplicity sake, use zip ties in place of hog rings when recovering and reattaching the parts.
--

While I would never deliberately mislead anyone, take into consideration that any info and advice was provided at no cost to you.
5 Volvos and a Roadmonster in SoCal, from '64 to '94. See profile for info.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Pictorial dismantling of 7/9-series front seats. [700]
posted by  Kane  on Fri Oct 27 10:42 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.