Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Thoughts on TABs 200

posted by  someone claiming to be 240_Newbie on  Fri Nov 3 20:13 CST 2006 [RELATED]

I'll likely be replacing my trailing arm bushings (TABs) in 2-3 weeks, so trying to find a quicker/easier way of doing them is always on my mind.

Would it be easier if I were to just cut through the metal sleeve with a reciprocating saw? Maybe make two cuts just inside the 'ears' so that the a center piece drops out and I just kind of muscle the remaining pieces out?

Gimmie your thoughts, please.

Thank you.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Thoughts on TABs [200]
posted by  someone claiming to be 240_Newbie  on Fri Nov 3 20:13 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.