Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 4/2020 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Thoughts on TABs 200

posted by  Erling on  Fri Nov 3 21:01 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed May 22 00:57 CST 2013
[RELATED]

I'd say it would work. I wouldn't say it would be easier though, not if they aren't totally rusted in place or act up for other reasons. You will need The Tool for installing the new bushings anyway, and normally the old ones will press out without too much hassle. Admittedly with some force, but still.

I had to put The Tool aside on one occasion and reach for the angle grinder (for the center part) and a hammer and chisel (to collapse the pieces left in the brackets). It was definitely not easier.



Good luck, whatever method you choose!

Erling.
--
My 240 Page






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Thoughts on TABs [200]
posted by  someone claiming to be 240_Newbie  on Fri Nov 3 20:13 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.