Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2002

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

240 Clutch releasing near end of stroke

posted by  morevert on  Fri Dec 22 03:28 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Apr 10 06:51 CST 2012
[RELATED]

I have a 1984 240 with 4spd. Clutch would release near bottom of stroke. Cable was adjusted near end of adjustment range, so replaced with new Sachs cable, thinking it had stressed. Both cables appeared to be same length & new cable made no improvement in getting clutch to release closer to the top of paddle stroke. Next tryed replacing with new Sachs disc, pressure plate & release bearing. Only slight improvement in getting clutch to release sooner & once again cable needed to be tightened near end of adjustment to get recommended paddle play & for clutch to release. The only variable left that I can see, is maybe the clutch yoke is bent.
Any thoughts?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 Clutch releasing near end of stroke
posted by  morevert  on Fri Dec 22 03:28 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.