Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Installing lock motor in driver's door 200 1987

posted by  Erling on  Wed Dec 27 03:04 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed May 22 00:57 CST 2013
[RELATED]

I have been struggling with fitting a lock motor without success and now I could need some help. Installing the motor itself is straightforward as the mounting holes are already there, the problem is the connecting rod.

I have saved all the rods, motors and wiring harness from a junker, so I have a variety of rods to try. And I thought one of them was a direct fit - see picture below. But, it will only fit if the lock knob is UP and the motor is DOWN, so it is about an inch too long.

Do I have to bend the rod to fit? Or have I missed something?



Erling.
--
My 240 Page






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Installing lock motor in driver's door [200][1987]
posted by  Erling  on Wed Dec 27 03:04 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.