Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Re-positioning engine, to install new motor mounts. 200 1986

posted by  Oliver240 on  Tue Jan 2 16:42 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jun 16 20:00 CST 2012
[RELATED]

My brother and I are working on replacing some old, tottaly worn out/broken motor mounts on our 240/86 171k. We've already taken out the splash guard, drained the oil, and jacked up the engine enough to take the oil filter out.(it was already that off center.) We haven't taken the mounts off yet because we're pretty sure we're going to have to re-allign the engine..So the question, is there a diy way of moving (re/alligning) the engine, so that when we go to put the new mounts on, everything will be in place. Other points, I think we need to move the engine in two directions, maybe a little foward and toward the passenger side.. Also should we try to do any of this before we take off the old mounts? Thankyou for any suggestions and help.
Thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Re-positioning engine, to install new motor mounts. [200][1986]
posted by  Oliver240  on Tue Jan 2 16:42 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.