Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2016 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

CAM GEAR 900 1993

posted by  chudar on  Tue Jan 23 10:39 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jun 13 20:29 CST 2014
[RELATED]

Good evening all, trying to remove cylinder head. All went well until I tried to remove the cam gear so I can slip the head from the inner timing belt cover. The bolt is torgued so tight I can't remove the bolt. I used a rubber scrap wrench to hold the cam gear, to no avail. I don't want to round the bolt edges. Is there a special tool to hold the cam gear for removal? I have an oil leak at the right rear of the head on want to take the head to machine shop to check for warpage. Any suggestions or ideas on how to remove the cam gear is greatly appreciated. Thanks in advance.

Darryl
1993 940 non-turbo 301k miles.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New CAM GEAR [900][1993]
posted by  chudar  on Tue Jan 23 10:39 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.