Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

1980 244 Condensation on intake manifold while running 200

posted by  rexall on  Thu Feb 8 13:54 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu May 10 17:59 CST 2007
[RELATED]

Does any body know what it means when the intake maniold is ice cold with heavy condensation on the flat area on top?I just got the car a few days ago.It doesn't start anymore but was succesful in getting it started yesterday.It ran for at least 10 minutes then seamed to run out of fuel.I noticed the condensation.Im still learning and have ordered a manual.Is that the cold start valve that aims into the big manifold just below the flat area on top?If so then could it be the reason for the ice cold manifold and pool of condensation?
Thats all for now.When I figure out what is what then I can ask more.I know you folks are much smarter than the RX7 group I joined to get info from.All kids! Thanks Chris
P.S. the condensation goes away after an hour or so after running.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1980 244 Condensation on intake manifold while running [200]
posted by  rexall  on Thu Feb 8 13:54 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.