Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

poking holes in my rocker panel dut to rust - what now? 200

posted by  someone claiming to be gj on  Sun May 13 10:19 CST 2007 [RELATED]

hello all,

i finally decided to remove the trim below my drivers side door to address the rust underneath and discovered it was a little worse than i thought.

basically, there's about a 6 x 4 section that is so rusted i can easily poke a hole in the metal.

i've researched the possibility of using por 15 etc. but i don't think this will suffice in this case.

is there anything i can do to fix this (i'm a definite rookie when it comes to body work) or should i just take it to a body shop and have them do it?

any suggestions?

gj





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New poking holes in my rocker panel dut to rust - what now? [200]
posted by  someone claiming to be gj  on Sun May 13 10:19 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.