Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

rear transmission seal - metal-rubber orientation 200 1982

posted by  82-244-gl on  Sun Jun 3 13:01 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon May 28 18:20 CST 2007
[RELATED]

I got the old seal and sleeve out of the flange OK.

The old seal was all rubber (no metal) and had a spring (ear ring like) washer behind it.
Well, maybe behind or it could have been inside it as it all flipped out at once.

Now, I have a replacement seal that is metal cup-like with rubber seal on one side and inside and metal at other end.

I have looked for pictures but cannot find one that is clear enough about how this new seal should be inserted.

Like what is front and back of the seal.

Do I put the metal cup part in first and press it up ro the sleeve?

Or do I put the rubber side in first, then press on the metal cup-like end
so that the rubber part meets the sleeve inside?

Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ANSWERED rear transmission seal - metal-rubber orientation [200][1982]
posted by  82-244-gl  on Sun Jun 3 13:01 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.