Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Ball joint question (strut anchor bolts- safety) 200

posted by  someone claiming to be Adirondack Blues on  Mon Jun 25 02:41 CST 2007 [RELATED]

Did my ball joints and complete tie rod assemblies on my '92 wagon (275k)yesterday. While removing the balljoints, I noticed that one of my 12mm strut anchor bolts on the driver side was sheared off such that it needs to be drilled out (I'm assuming by whoever attempted to do the ball joints ~100k ago. I didn't have time to extact the bolt yesterday (access was a real PITA), so I put her back together and am now running with only three strut anchor bolts on that side. Dumb idea? PArt of me tells me I should take it apart and drill 'er out, however I'm also assuming it had been like that for the last 100k or so with no problems so maybe I shouldn't worry. Any thoughts?

Thanks for listening.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ball joint question (strut anchor bolts- safety) [200]
posted by  someone claiming to be Adirondack Blues  on Mon Jun 25 02:41 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.