Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 sway bar bushing install 200 1988

posted by  chickenricekid on  Thu Sep 27 16:54 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri May 8 12:56 CST 2009
[RELATED]

So i installed front sway bars from IPD, using the bushings that they supplied. When i screwed the bushings on the tie rods though, the bushings didn't seat correctly. They were kind of crooked, and squished on one side, sticking out on another. I tried taking a photo of it off my iPhone if this helps. Sorry bad lighting, but you can see the bushings poking out the top and bottom

I want to know if this is safe, and if i should continue tightening it? or am i doing something wrong?







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 sway bar bushing install [200][1988]
posted by  chickenricekid  on Thu Sep 27 16:54 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.