Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

rear caliper pins 700

posted by  someone claiming to be cr on  Fri Dec 7 14:14 CST 2007 [RELATED]

1991 740 b230f sedan

just replaced my rear brake pads, and my thanks to those who prepared the FAQ, which described very well how to do it...

purchased, with the oem pads, a hardware kit which included 4 replacement caliper pins from FCP Groton. Everything went well - except for the caliper pins. The old ones were recessed flush to the caliper surface(on the inside side)...the new pins, no matter how hard I hit them with my flat punch, will not go fully into the recess - they stick out about 1/8 of an inch. The tapered pin does extend out on the outside of the caliper.

Is this a problem? or is it ok that they stick out a bit?

thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New rear caliper pins [700]
posted by  someone claiming to be cr  on Fri Dec 7 14:14 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.