Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2005

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

center support bearing/bushing=where to find best quality

posted by  transit wind on  Tue Dec 11 12:47 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Aug 15 22:40 CST 2014
[RELATED]

I have a support bearing bushing that looks like its all cracked and ready to go. The bearing is making the winter howl at times, for the 4th year now. After searching the archives and FAQ I had to wonder if maybe the easiest approach is to just replace the bushing. I have a vibration on take off and assumed it was a u-joint but from what I've been reading it could be the bushing.

If I just decided to replace the bushing then no pressing would be needed right cause the bearing would be re-oiled and left on. That sounds nice. But if I decide to replace the bearing where can I find the best brand (best quality). I'm not sure about Scantech at FCP Groten. Not looking to do this job again on this car for a long time.

Also finding the diameter of the driveshaft? I assume you just hold the measuring tape under it and eye the width? Or is it measured all the way around the shaft?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New center support bearing/bushing=where to find best quality
posted by  transit wind subscriber  on Tue Dec 11 12:47 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.