Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

I'm having a problem installing new PS motor mount...Help!!! 200 1986

posted by  Xraybob on  Sat Dec 29 06:01 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

I thought this would be easy....wrong. The old passenger side motor mount came out with no issues. I removed the alternator so I could put new accessory mounts in at the same time. But when I tried to reinstall the the motor mount, the three bolts that go into the block are sitting about 3/4" above the holes in the block. I loosened the nuts on the DS so when I raised the engine, thinking that would give it even play in upward movement to meet the bolts, but again, no luck. Any suggestions? I'm starting to get a headache over this....I think it's stress......

Thanks.
--
'86 sedan with 376K miles with original engine and automatic transmission






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New I'm having a problem installing new PS motor mount...Help!!! [200][1986]
posted by  Xraybob  on Sat Dec 29 06:01 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.