Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

What did I break? 200

posted by  volvosfive on  Sat Jan 26 14:44 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 21 08:01 CST 2011
[RELATED]


I was swapping in a used engine into my '91 240 a few weeks ago. The transmission (auto AW-71) was about an inch from being flush with the rear of the engine, so I put in the bolts and started tightening it down. I really knew better than to do this. Upon getting it back in the car I noticed that the engine wouldn't spin by hand. I pulled everything back out and now the engine will spin with the transmission removed. Also, the problem now is that the torque converter won't pull off of the input shaft on the transmission. It slides toward the end to a certain point, but won't come off. Any idea what kind of damage I did to this thing? I was just in a hurry but now I wish I would have been more careful putting the engine/trans together.

Thanks in advance!
Dave






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New What did I break? [200]
posted by  volvosfive subscriber  on Sat Jan 26 14:44 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.