Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

New O2, now idles rough.... 200

posted by  a Volvo believer on  Sun Mar 9 17:33 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Nov 29 22:36 CST 2013
[RELATED]

Purchased new Bosch 3-wire exact fit O2 sensor from Groton, installed it, immediately after installation engine now idles very rough all the time, and check engine light now comes on. Never had any trouble with that light before this. Digital voltmeter on O2 lead while plugged into computer reads only .05 volts(not .50) all the time. Heater wires on sensor have 2.3 ohms which is ok, and heater wire harness from car has 12 volts. If I unplug O2 sensor wire to computer, idle is immediately smooth.

I did not make any other changes or adjustments at the time I did the O2 sensor replacement.

Has anyone else had this problem with new O2 sensors, and if so, what solved it?

--
'89 silver 244DL in Milwaukee WI






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New New O2, now idles rough.... [200]
posted by  a Volvo believer subscriber  on Sun Mar 9 17:33 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.