Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

'89, have tbl codes 312,113,221: need tips on how to begin... 200 1989

Wife's '89 244, 170K: Check engine light came on and produced following codes:
312 - knock sensor
113 - Oxygen sensor (?)
221 - Bad AMM, air leak or low fuel pressure.

I plan to inspect all hoses and connectors, roll fuses again, and recheck codes. I reset codes to zero two days ago, but same 3 codes re-appeared.

Car runs fine and I notice no difference in performance.

1. Knock sensor: not sure how to approach that. Find it and replace it maybe.

2. Oxygen sensor: I guess I could just replace that. Last time was about 60K miles ago.

3. AMM, air leak or fuel pressure: I can clean AMM connector or try blowing out the guts in the AMM...I've never dealt with it before, (owned car since new). Air leak: just look around. Fuel pressure: I have no gauge.

Any comments on how to interpret these codes would be appreciated. Thanks, Dennis






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New '89, have tbl codes 312,113,221: need tips on how to begin... [200][1989]
posted by  dbt  on Thu Mar 20 19:37 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.