Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

What are reasons I get no codes when trying to retrieve them? 200 1990

posted by  Strackerjack on  Sat Mar 22 12:09 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 8 19:11 CST 2014
[RELATED]

I have been troubleshooting a no start condition and I've tried to read the codes to see if they might give me a clue.

Unfortunately when I go through the described process:

put jumper wire into slot (2 or 6), turn key to position 2, press button longer than 1 sec., no longer than 3 seconds, read sequence of LED flashes...

the LED lights when I press the button but no lights flash after that.

the wires to the code block seem ok...

anyone ever experience this... do I have the sequence correct?

thanks,

jack
--
Bad Blue - '86 245 with 303,000 mi., Blacky - '91 740 wagon with 180,000 mi., Mean Green - '94 850 with 222,000






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New What are reasons I get no codes when trying to retrieve them? [200][1990]
posted by  Strackerjack subscriber  on Sat Mar 22 12:09 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.