Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Modifications to engine mounts 200 1985

posted by  Stickbuilder on  Mon Apr 14 13:41 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 03:31 CST 2014
[RELATED]

I am about to replace my engine mounts. I bought the Myele set, and have been thinking about protecting the rubber part of these mounts from any oil contamination especially during oil changes. I have an idea of making a shield out of something such as a tin can that I would cut to length, and with the correct holes drilled in the end, would allow the rubber mount to be completely covered, and therefore protected from any oil contamination such as we get when removing the oil filter. Does anyone have any ideas on this, or am I just spitting into the wind with this?

Bill






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Modifications to engine mounts [200][1985]
posted by  Stickbuilder subscriber  on Mon Apr 14 13:41 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.