Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Please look at these Brembo rotors that FCPGroton shipped me. 200 1989

posted by  Andrew240 on  Sun Apr 20 12:57 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri May 4 15:33 CST 2012
[RELATED]

I purchased a set of Volvo pads and Brembo rotors for the front axle of my 240. I only bothered to open one of the rotors for inspection. So today I am changing out my pads/rotors, and I noticed that one of the rotors does NOT have the same surface finish as the other rotor. Since this is my daily driver, I had to finish up with the rotors that I had on hand (my old ones were stuck on, and I hit them off with a ball peen hammer).

The one rotor has the typical vinyl record look to it. The other one looks like it has been stuck on a belt sander and rotated. It has NO ridges like you would expect. They seem to be the same thickness. I did not have a caliper gauge to measure. Should I contact FCP and have them send me a new rotor? What about the Volvo pads that I had to break in on this rotor? Any help would be appreciated. Sorry for the picture quality, I only had my camera phone with me.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Please look at these Brembo rotors that FCPGroton shipped me. [200][1989]
posted by  Andrew240 subscriber  on Sun Apr 20 12:57 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.