Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2005 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Hub adapter for Italvolanti steering wheel 140-160

posted by  volvoid on  Thu May 1 06:30 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Nov 15 02:30 CST 2010
[RELATED]

I just tried to mount a 1980s 14" 4-spoke Italvolanti Corsa wheel on my 1974 164e. The adapter that came with it is a really close fit, but won't go down far enough for the horn brush to make contact. IPD says there were three adaptors for 140s/160s: one for '72 & earlier, one for '73, and one for '74 and later. Does anyone know how to tell them apart and/or have any ideas for getting this too fit? (could I use a couple small washers to push the brush out? It's less than 1/4" off.) Alternately, does anyone have a '74 adapter they'd want to sell or trade?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hub adapter for Italvolanti steering wheel [140-160]
posted by  volvoid  on Thu May 1 06:30 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.