Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2019 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

driveshaft center support bearing ...R&R questions 200

posted by  jjnuttall on  Mon May 12 03:13 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Apr 28 14:42 CST 2011
[RELATED]

Hi All,

I have read Bentley, the FAQ and a bunch-o-threads, but I have a couple of questions before I tackle this task:

1) I am making a bearing puller and I would like to know the distance from the rear of the front 1/2 shaft to the "front side" of the bearing. Referring to Fig 8 on page 450-4 in Bentley it appears to be about the same dimension as the width of the rubber mount.

2) do you have any procedural time savers to offer?....

TIA,
John





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New driveshaft center support bearing ...R&R questions [200]
posted by  jjnuttall  on Mon May 12 03:13 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.