Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 seat foam interchangeability. From my '84 to my '88? Will it work? 200 1988

posted by  jgreenwood on  Thu May 22 05:52 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Sep 11 19:10 CST 2011
[RELATED]


Hi guys. Back to the well for more help. The '88 I am restoring has nice blue upholstery with no rips and very little wear. But the foam on the driver's side is shot to the point that the metal frame on the right has come thru the foam. There is very little support on the left anymore either. However, the '84 242 that I use for parts now (used to drive) has nice foam on the passenger side, seat and back. Can I take the old ripped leather off that foam, remove the foam and put in on my '88 driver's side frame without a lot of modification? I can't spring for the new IPD foam ($300+ plus shipping) AND buy gas to drive it. Will this work or have the frames and foam changed since '84? All ideas are welcome. And thanks ahead of time.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 seat foam interchangeability. From my '84 to my '88? Will it work? [200][1988]
posted by  jgreenwood subscriber  on Thu May 22 05:52 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.