Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Control Arm Bracket - Broken Weld nut 200 1990

posted by  KarlHarnish on  Mon Jun 9 13:51 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Jul 17 17:58 CST 2014
[RELATED]

I am in the process of replacing my front control arm bushings. When I loosened the the 3rd bolt - the one towards the back and middle, I broke the weld nut. I was able to get the bracket off. (Those in the mid west probably have heard me cussing the bushings!)

I now need to figure out how to re-attach the bracket. The Weld nut is inside the center section of the frame's side member, and I don't really want to cut a hole in the side member to access a new nut. My best idea so far is to drill a hole in the floorboard, right under the gas peddle (about where your heel would be when you are driving) to get access to the inside of the side member.

I called the people at IPD, but they had never heard of this happening, so they had no concrete suggestions.

Please help!

Karl Harnish
Athens, Ohio






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Control Arm Bracket - Broken Weld nut [200][1990]
posted by  KarlHarnish  on Mon Jun 9 13:51 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.