Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2001 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

R & R of rear "rubber 444-544 1958

uid 37415's pic
posted by  Old Kombi on  Sat Jun 14 14:07 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Sep 30 01:42 CST 2010
[RELATED]

Hi all:
Anyone have any good tips or techniques for replacing the bushings on the 444 (544 the same I think) rear suspension? I am going to replace with IPD poly bushings and am doing the "U" shaped bushings around the axle housing as well as the front pivots of the swing arms that connect to these. I have already done the torque rods at the top of the diff.
This stuff looks a bit different than the 122 I am used to! I am thinking I should do one "side" at a time (U bushing and pivot) but am certainly open to a better way if its out there! At this time I hope not to have to remove the arms themselves, will this create problems?


TIA & Cheers!
OK






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.