Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2007 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How do you cut off a water pump nut with broken threads? 700 1989

posted by  lucast on  Sun Jun 29 00:51 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Sep 24 00:38 CST 2011
[RELATED]

Whilst installing a new water pump, I over-torqued both a nut and a bolt. Nut got stripped - i.e., the threads broke and its just spinning on the engine stud. And then the bolt broke off. That'll teach me not to do things in a hurry :-(

I need to get the nut off before I can remove the broken bolt. As things stand, the pump is very very stuck.

What would you suggest to use to cut off the nut?

I read somewhere that that a Dremel tool might be used for cutting a nut. Which attachment should I use?

Thanks!

Lucast






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How do you cut off a water pump nut with broken threads? [700][1989]
posted by  lucast subscriber  on Sun Jun 29 00:51 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.