Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

240 wheel bearing replacement questions 200 1987

posted by  ClearDark on  Sat Aug 9 11:29 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Sep 11 15:18 CST 2008
[RELATED]

Been working on the wheel bearings today on the 240.

I have a slight problem. The inner wheel bearing race will snug down into the hub, but it wont butt up against the bevel that was machined. There is a small gap between the race and the machining in the hub.

Is this normal? The haynes manual is less than descriptive. In fact it doesnt say much of anything. I havent got to the outer yet...so hopefully that will go ok.

Also, I cant seem to find the grease seal anywhere in stock locally. Is it ok to re use the old one or should I wait and find a new one? I really need this back together asap as it's my main driver and can't go without.

Any quick help is appreciated, especially on the wheel bearing race thing. Thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 wheel bearing replacement questions [200][1987]
posted by  ClearDark  on Sat Aug 9 11:29 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.