Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Help! How to keep screw clips on blower motor in place? 200 1989

posted by  lrisius on  Fri Sep 12 04:01 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 17 05:59 CST 2014
[RELATED]

Hi,
I'm doing a hole-saw blower motor replacement on my 240. When removing the old blower motor, the clips that the screws thread through on the back came loose. How do I hold those in place for the re-install? They have sharp legs that I think maybe should hold them in place but haven't had any luck with that yet. Which way should the pointy things point- to or away from the screw head?

Any help would be greatly appreciated.
Thanks!
Lyle






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help! How to keep screw clips on blower motor in place? [200][1989]
posted by  lrisius  on Fri Sep 12 04:01 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.