Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

92 240 performance upgrade 200

posted by  mountainman on  Tue Oct 21 14:29 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Aug 13 05:13 CST 2010
[RELATED]

I was wondering if any of you more folks with more experience with the 240 could give me advice. I have a bone stock 92 240 with a 5 speed. It had good torque down low but runs out of air before it revs up enough to make any HP. I ordered a K cam and adjustable gear from Avalanche Performance, but I don't want to install it until I have the other parts needed to make it work well.

My question is, assuming that cam is capable of moving more air and producing more HP (obviously at the expense of low end torque) where will the flow restriction be? Should I look at the intake or the exhaust? I could have the intake extrude honed for about what a long tube header costs.

Which side of the head should I be looking at to remove restriction? Anyone have any experience with the "K" cam they would like to share?
Thanks in advance!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 92 240 performance upgrade [200]
posted by  mountainman  on Tue Oct 21 14:29 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.