Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2013 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

power steering pulley installation nightmare. 900 1997

posted by  someone claiming to be JMS90 on  Wed Nov 12 11:37 CST 2008 [RELATED]

Im replacing the power steering pump, got a refurb without the pulley on it. So I had to use my old one. Got it off with a pully puller easily. BUT I cannot for the life of me put the pulley on the new pump. The pump came with a kit (bolt/nut/washer) to push it in and I am using it correctly. The pump shaft gets half way to where it should be then stops.

Using huge amounts of leverage and even commiting the bad of putting the pulley in a table vice. I put wd40 in it and grease. I even did some sanding of hole in the pulley. The pumps look the same I just cant figure it out. I wasted hours, if anyone can offer advice or support it would be MUCH appreciated.

---
97' 960/S90 w 70K






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New power steering pulley installation nightmare. [900][1997]
posted by  someone claiming to be JMS90  on Wed Nov 12 11:37 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.