Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Help! Ignition wiring harness problem - '86 240 200

I've been having a problem with the car stutting during acceleration, and I was changing stuff to see if I can get it to stop. I was checking to see if the knock sensor wire was plugged in correctly, I discovered the car starting to stutter, the idle started to fluctuate and the car died (the car will start right up again). When the ignition is on-car not running, I could hear something clicking when I would wiggle these two wires:

Photobucket

I traced the clicking to the fuel injectors. The clicking only occurs when both of these wires are connected to the coil.

I replaced the engine harness a couple years ago with a replacement harness. Are these two wires part of the ignition wiring harness?

Can I run some new wires to get the car running right again. Where do they go?

Paul






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help! Ignition wiring harness problem - '86 240 [200]
posted by  malloy1  on Sat Dec 6 07:53 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.