Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Intermediate shaft and rotor alignment 200 1992

posted by  elguadas on  Mon Dec 22 06:45 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu May 3 14:19 CST 2012
[RELATED]

Hello all,

I am in the middle of replacing my Volvo 240 headgasket and decided to replace the engine front seal while I am there. I also went ahead and removed the aluminum cover that holds the intermediate and crank seals. My problem startted when I was trying to remove/scrape the cover gasket, I accidentally pulled the intermediate shaft too much to the point that it came out of its place and now I need to put it back together. Re-inserting the shaft is easy; the problem is making sure the distributor rotor points to the right direction while the sprocket aligns with the timing mark.

I am asking for all of your expert advise to help me put it together.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Intermediate shaft and rotor alignment [200][1992]
posted by  elguadas  on Mon Dec 22 06:45 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.