Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Finished tranny conversion, now NO START 200

uid 29404's pic
posted by  punk240 on  Fri Jan 16 10:27 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jul 14 15:23 CST 2014
[RELATED]

I'm really scratching my head on this one...

Swapped an 87 M47 into a 92 240 (AW70)
Getting the Clutch/Brake block in required some wires to be moved around.
All fuses are good.
I hear fuel pump priming.
I recalled in BB that someone mentioned the Inst. Cluster does NOT need to be connected to operate the vehicle. I installed it anyway.
Battery shows 11.65 volts.

The triangular Shifter Switch was cut off and the dual gray wires for the OD Switch was cut. The thicker white wire that ran thru the front of the Shifter Housing was cut...
Does the newer models HAVE to have any of the old shifter wires jumpered to fool the ECU into proper operation? I've seen some advertised ECU that state "Came from Manual Shift 240" - is this even a factor?

Up in the air
Tim
--
'92 244 AW71 (Hydra, turbo bars, bilstein, urethane bushings)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Finished tranny conversion, now NO START [200]
posted by  punk240  on Fri Jan 16 10:27 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.