Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2004 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

exhaust bracket help 900 1993

posted by  dinomartino on  Sun Feb 8 07:19 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 04:43 CST 2014
[RELATED]

Am in process of replacing the gasket between manifold and downpipe to seal an annoying exhaust leak on my NA 945. The nuts came off the studs with no problem. However, the bracket that comes off the bellhousing to support the downpipe is severely corroded where it attaches to the downpipe, and I have been unable to budge the bolts at all. Access is extremely tight back there (no room for breaker bar).

Is it okay to remove the two bolts for the bellhousing that appear to pass through this bracket? Is it indeed held on with only those 2 bolts? That's the only way I can see to get enough play in the exhaust system to separate the joint and install the new gasket.

Must finish this today, need advice asap.

thanks,
John






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New exhaust bracket help [900][1993]
posted by  dinomartino subscriber  on Sun Feb 8 07:19 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.