Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2013 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

fuel injector caps - go with out them? 900

posted by  beartrap on  Fri Apr 24 09:13 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jan 31 11:41 CST 2011
[RELATED]

1994 940 non-turbo B230 170,000 miles

I just took off my fuel rail yesterday to reseal the injectors, there was definitely a lot of build up around the tips, I'm assuming thats normal. None of the injectors had the little plastic caps though - is that okay?

I wiped everything down and popped on two new o-rings with out putting the new caps from the set on. Once I put everything back together everything seemed to run well, is it okay to go without the caps?

In the beginning I did try to put one on, but it seemed too tight to fit properly - so I just decided to keep them all off.

And I do want to thank whoever posted the tip about pulling the fuel pump fuse to release the fuel pressure, it worked perfect with minimal gas spillage.






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.